SPECIAL PRODUCTSAntigraf - Kraft Paints

Graffiti protection for interior and exterior surfaces

Antigraf is water-based graffiti and spray paints sacrificial protective coating. It is easy to apply, user and environmentally friendly, UV resistant, fully permeable and does not alter color or texture of the applied substrate. It can be applied on concrete, stucco, plaster, marble, natural stone, and prepainted surfaces. The surface must be re-protected with KRAFT ANTIGRAF, following graffiti removal with hot water and pressure washers.

Araiosi_01

Thinning
0%

Araiosi_01

Coverage
8-12m2/L

Araiosi_01

Tools
Roller, brush or airless or air-assisted spray gun

Araiosi_01

Dry to touch
1-2 hours

Packaging

18 L

Shades

Transparent



  • Instructions
  • STORAGE

Instructions

SURFACE PREPARATION AND APPLICATION
To ensure proper adhesion the surface must be dry, clean and free of dust, oil, salt, rust, loose paint and residues, blistered paint etc. Remove all moss, fungi and algae by mechanical abrasion and wash with soapy water and allow the substrate to dry.
» It is recommended that fresh concrete, stucco, plaster and gypsum surfaces are allowed to dry for at least 28 days before the application of the coating system.
» Apply one coat and allow to dry. Remove excess material after 15min. It is recommended to apply a second coat for higher protection after 3 hours.
» On very porous substrates: Apply one coat of KRAFT MARBLE AQUA 24 hours before applying the first coat of KRAFT ANTIGRAF under favourable drying conditions.
|» For graffiti removal: Use hot water (>60oC) and soak the surface so that it is kept dripping for approximately 2-4 minutes. Peel off and remove KRAFT ANTIGRAF from the side with a high-pressure hot water unit. Adjust water pressure according to the surface. Once the graffiti has been removed, thoroughly wash the surface with hot water and re-protect cleaned area with KRAFT ANTIGRAF.

APPLICATION INSTRUCTIONS
» 
Tools: Roller, brush or airless or air-assisted spray gun.
» Cleaning: The tools and spillages may be cleaned immediately with soapy water.
» Thinning: No dilution is recommended.
» Dry to touch: 1-2 hours at 25ºC and RH 50% (drying times are longer at lower temperatures and at higher relative humidity).
» Dry to Recoat: 3 hours under favourable drying conditions.
» Full cure: Maximum protection is achieved after 24 hours.
» Stir well with a flat paddle, before application, and at regular intervals during application.
» Do not apply at temperatures below 10ºC or above 35ºC or at humidity levels above 65%.
» Do not apply if rain is imminent.

APPLICATION INSTRUCTIONS
» 
Tools: Roller, brush or airless or air-assisted spray gun.
» Cleaning: The tools and spillages may be cleaned immediately with soapy water.
» Thinning: No dilution is recommended.
» Dry to touch: 1-2 hours at 25ºC and RH 50% (drying times are longer at lower temperatures and at higher relative humidity).
» Dry to Recoat: 3 hours under favorable drying conditions.
» Full cure: Maximum protection is achieved after 24 hours.
» Stir well with a flat paddle, before application, and at regular intervals during application.
» Do not apply at temperatures below 10ºC or above 35ºC or at humidity levels above 65%.
» Do not apply if rain is imminent.

STORAGE

» Store in dry conditions at temperatures between 5°C and 35°C.
» Keep containers tightly closed when not in use.

NEWSLETTER

Μάθετε πρώτοι όλα τα νέα.