WATERPROOFINGCEMENTSHydroguard Elastic - KRAFT Paints

Cement mortar system for waterproofing

KRAFT HYDROGUARD ELASTIC is a 2-component waterproof, acrylic modified, cement-based, heavy-duty masonry mortar which stops water penetration and prevents water damage while protecting concrete and other masonry surfaces subject to flexural strain. It is applied on both vertical and horizontal surfaces of buildings. It is applied on both vertical and horizontal surfaces of buildings. It can be used on weather exposed roofs, terraces and balconies tanks, concrete surfaces subject to flexural strain.
It has been tested and it is approved for contact with potable water according to C.M.N. Υ2/2600/2001. It meets the requirements defined by ΕΝ 1504-2 for surface protection coating system.

» Easy to mix and use
» 
Ease of application
» 
High water vapor permeability
» 
Extremely low water absorption
» 
Highly flexible
» 
Excellent adhesion to mineral substrates and EPS, XPS panels
» 
Heavy-duty
» 
UV resistant
» 
High solar reflectance
» 
Crack bridging properties

Araiosi_01

Mixing ratio
7.5Kg Hydroguard Elastic per 18Kg Hydroguard One

Araiosi_01

Consumption
1.0-1.5Kg/m²/coat

Araiosi_01

Tools
brush, roller or airless spray gun

Araiosi_01

Workability
45 min

Packaging

2 kg, 7.5 kg

Shades

White



  • Instructions
  • STORAGE

Instructions

SURFACE PREPARATION
To ensure proper adhesion, the surface must be dry, clean and free of dust, fat, salt, rust, loose paint and residues, blistered paint, etc. Damaged, delaminated or weak concrete must be repaired using KRAFT STRONG REPAIR 84.
» Before applying the mixture the substrate must be wetted with water by spraying.

APPLICATION INSTRUCTIONS
Pour KRAFT HYDROGUARD ELASTIC (Comp. B) into a suitable mixing container and add KRAFT HYDROGUARD ONE (Comp. A) slowly while mixing with a low-speed electric drill mixer. Mix thoroughly at least for 3-4 minutes, until the proper lump-free consistency is reached.
» Do not add any additional water or other ingredients.
» Each packaging unit must be entirely mixed, to avoid faulty particle size distribution of aggregates contained in the powder component.
» KRAFT HYDROGUARD ELASTIC can be applied by brush, roller or trowel in two coats crosswise to maximum of thickness of 1mm per coat where waterproofing is available.
» In highly stressed areas a special alkali-resistant glass fiber net HYDROGUARD NET (70-80g/m²) shall be placed into the first fresh mortar layer. It shall be well trimmed and fully embedded into the mortar avoiding the formation of voids in the coating.
» Potlife: 45min at 25ºC.
» Dry to recoat: 2-5 hours in favorable weather conditions.
» Clean all tools and application equipment with water immediately after use. Hardened material can only be mechanically removed.
» Stir well before use and during application.
» Do not apply at temperatures below 10ºC and above 35ºC as well as at relative humidity levels above 80%.
» Do not apply if rain is imminent.
» Avoid application in direct sunlight and/or strong wind.

STORAGE

» Comp A: Stored for 12 months by the production date in its closed and sealed packages, in dry and cool condition preferably on pallets.
» Comp B: Store in dry conditions at temperatures between 5°C and 35°C. Keep containers tightly closed when not in use

NEWSLETTER

Μάθετε πρώτοι όλα τα νέα.