REPAIRMORTARSPowder Bond - KRAFT Paints

Acrylic admixture latex for concrete and mortars

Special acrylic bonding and waterproofing latex, which significantly improves the properties of cement mortars such as plasters, floor screeds, smoothing and repairing mortars and tile adhesives. It increases adhesion to any substrate. It improves elasticity and waterproofing, preventing shrinkage and hairline cracks in screeds and coatings. It also improves the water retention and workability, and protects fresh concrete against premature dehydration. It can be also used as a primer for paints and roof waterproofing materials and mainly for waterproofing in foundation materials in construction.

» Improves adhesion and waterproofing of cement mortars
» 
Increase of resistance, elasticity and sealing
» Prevents shrinkage
» Reduces cracking

Araiosi_01

Thinning
100-300%

Araiosi_01

Coverage
20-40m2/L

Araiosi_01

Tools
brush, roller, air or airless gun

Araiosi_01

Dry to touch
1-3 hours

Packaging

1 L, 4 L

Shades

Milky



  • Instructions
  • STORAGE

Instructions

SURFACE PREPARATION
Surfaces must be clean, dry and free from all defective and poorly adhering materials, dirt, grease and salts. Moisten cementitious substrates to saturation.

APPLICATION AS ADMIXTURE
» Pour water and KRAFT POWDER BOND into a suitable mixing container and add cement based mortar slowly while mixing.
» Mix thoroughly at least for 3-4 minutes, until the proper lump-free consistency is reached.
» Do not apply at temperatures below 10ºC and above 35ºC as well as at relative humidity levels above 80%.

APPLICATION INSTRUCTIONS
» Tools: Paintbrush, roller, air or airless gun.
» Cleaning: Immediately after use, wash the tools with hot water and soap or detergent along with product residues.
» Thinning: 100%-300% with water according to the substrate’s absorbing capacity.
» Theoretical coverage: 20-40m2/L, depending on surface porosity, painting conditions and application method
» Dry to touch: 1-3 hours, at 25ºC and 50% relative humidity (drying times are longer under humid/cold conditions).
» Do not apply at temperatures below 10ºC and above 35ºC as well as at relative humidity levels above 80%.
» To avoid skinning and film formation use low levels of thinning on porous substrates and higher levels of thinning on less porous substrates.

STORAGE

» Store in dry conditions at temperatures between 5°C and 35°C. Keep containers tightly closed when not in use.

NEWSLETTER

Μάθετε πρώτοι όλα τα νέα.